Manual: remove most HWCODEC artifacts

This causes 3 changes in layout. 2 I can't track down and 1 is better this way.

Change-Id: If4ad5e1d7431b4c2cbaaf9767d78139ef4e2dc44

1 files changed, 11 insertions, 16 deletions

diff --git a/manual/configure_rockbox/recording_settings.tex b/manual/configure_rockbox/recording_settings.tex
index 9a5ddb30a6..1abd38c536 100644
--- a/manual/configure_rockbox/recording_settings.tex
+++ b/manual/configure_rockbox/recording_settings.tex
@@ -6,16 +6,14 @@
       where you want to store them in the \setting{File Browser} and select
       \setting{Set As Recording Directory}.}
 
-\opt{swcodec}{
-  \section{Format}
-    Choose which format to save your recording in. The available choices are
-    the two uncompressed formats \setting{PCM Wave} and \setting{AIFF}, the
-    losslessly compressed \setting{WavPack} and the lossy
-    \setting{MPEG Layer~3}.
+\section{Format}
+  Choose which format to save your recording in. The available choices are
+  the two uncompressed formats \setting{PCM Wave} and \setting{AIFF}, the
+  losslessly compressed \setting{WavPack} and the lossy
+  \setting{MPEG Layer~3}.
 
-  \section{Encoder Settings (MP3 only)}
-    This sets the bitrate when using the \setting{MPEG Layer~3} format. 
-}
+\section{Encoder Settings (MP3 only)}
+  This sets the bitrate when using the \setting{MPEG Layer~3} format. 
 
   \section{Frequency}
    \nopt{ipodnano,ipodcolor,ipod4g}{
@@ -39,9 +37,8 @@
         22.05~kHz, 16~kHz, 12~kHz, 11.025~kHz and 8~kHz}
     are available. Higher sample rates use up more disk space, but give better
     sound quality.
-    \opt{swcodec}{\note{The 11.025~kHz setting is not available when using %
+    \note{The 11.025~kHz setting is not available when using %
       \setting{MPEG Layer~3} format.}
-    }
     \opt{recording_digital}
       {\note{You cannot change the sample rate for digital recordings.}
     }
@@ -80,11 +77,9 @@
   for mono recording, only the left channel is recorded. Mono recordings
   are usually somewhat smaller than stereo.
 
-\opt{swcodec}{
-  \section{Mono Mode}
-    When configured to record to mono and the source is a stereo signal, use this
-    setting to configure how the mono signal is created. Options are L, R and L+R.
-}
+\section{Mono Mode}
+  When configured to record to mono and the source is a stereo signal, use this
+  setting to configure how the mono signal is created. Options are L, R and L+R.
 
 \section{File Split Options}
   This sub menu contains options for file splitting, which can be used to split