diff options
Diffstat (limited to 'manual/configure_rockbox/main.tex')
| -rw-r--r-- | manual/configure_rockbox/main.tex | 105 |
1 files changed, 46 insertions, 59 deletions
diff --git a/manual/configure_rockbox/main.tex b/manual/configure_rockbox/main.tex index 5305a0781e..7e14c3c573 100644 --- a/manual/configure_rockbox/main.tex +++ b/manual/configure_rockbox/main.tex @@ -1,75 +1,58 @@ \chapter{Configuring Rockbox} \section{Sound Settings} -{\centering\itshape - [Warning: Image ignored] % Unhandled or unsupported graphics: -%\includegraphics[width=4.15cm,height=2.371cm]{images/rockbox-manual-img32.png} - \textmd{ } [Warning: Image ignored] -% Unhandled or unsupported graphics: -%\includegraphics[width=4.15cm,height=1.951cm]{images/rockbox-manual-img33.png} - \newline -Recorder sound settings Player sound settings -\par} +\begin{center} +\includegraphics[width=4cm]{configure_rockbox/images/ss-sound-setting-\genericimg.png} +\end{center} -This menu offers a selection of sound properties you may change to -improve your sound experience. +This menu offers a selection of sound properties you may change to improve your sound experience. \begin{itemize} \item \textbf{Volume} - -The sound volume your music is played at. Although settable range is -0{}-100\%, many units don't produce audible output -below 40\%. On Recorders, volume settings above 92\% will cause -distortion (clipping) and are not recommended. - + The sound volume your music is played at. + \opt{recorder,recorderv2fm,player,ondio}{\textbf{TODO fix text} + Although settable range is 0{}-100\%, many units don't produce audible output below 40\%. On Recorders, volume settings above 92\% will cause distortion (clipping) and are not recommended.} + \opt{h1xx,h300,ipodcolor,ipodnano,ipodvideo}{\textbf{TODO write target specific text}} \item \textbf{Bass} -This emphasises or suppresses the lower -(bass) sounds in the track. 0 means that bass sounds are unaltered -(flat response). - + This emphasises or suppresses the lower (bass) sounds in the track. 0 means that bass sounds are unaltered (flat response). \item \textbf{Treble} -This emphasises or suppresses the higher -(treble) sounds in the track. 0 means that treble sounds are unaltered -(flat response). - +This emphasises or suppresses the higher (treble) sounds in the track. 0 means that treble sounds are unaltered (flat response). \item \textbf{Balance} -How much of the volume is generated by the left or right channel of the -sound. The default, 0, means that the left and right outputs are equal -in volume. Negative numbers increase the volume of the left channel -relative to the right, positive numbers increase the volume of the -right channel relative to the left. - + How much of the volume is generated by the left or right channel of the sound. The default, 0, means that the left and right outputs are equal in volume. Negative numbers increase the volume of the left channel relative to the right, positive numbers increase the volume of the right channel relative to the left. \item \textbf{Channels} - -This option controls the on{}-board mixing -facilities of the Jukebox. A stereo audio signal consists of two -channels, left and right. Available options are - -\begin{itemize} -\item \textbf{Mono Left: }Plays the left channel in both stereo channels. -\item \textbf{Mono Right:} Plays the right channel in both stereo channels. -\item \textbf{Mono:} Mix both channels down to mono and send the mixed signal -back to both. -\item \textbf{Stereo:} Do not mix the signal -\item \textbf{Stereo Narrow: }Mixes small amounts of the opposite channel into -the left and right channels, thus making the sound seem closer -together. -\item \textbf{Stereo Wide:} Elements of one channel that are present in the -opposite channel are removed from the latter. This results in the -sound seeming further apart. -\item \textbf{Karaoke:} Removes all sound that is the same in both channels. -Since most vocals are recorded in this way to make the artist sound -central, this often (but not always) has the effect of removing the -voice track from a song. -\end{itemize} - -\item \textbf{Loudness (Recorder only)} + + \opt{player,recorder,recorderv2fm,ondio}{ + This option controls the on{}-board mixing facilities of the Jukebox. A stereo audio signal consists of two channels, left and right. Available options are + \begin{itemize} + \item \textbf{Mono Left: }Plays the left channel in both stereo channels. + \item \textbf{Mono Right:} Plays the right channel in both stereo channels. + \item \textbf{Mono:} Mix both channels down to mono and send the mixed signal + back to both. + \item \textbf{Stereo:} Do not mix the signal + \item \textbf{Stereo Narrow: }Mixes small amounts of the opposite channel into + the left and right channels, thus making the sound seem closer + together. + \item \textbf{Stereo Wide:} Elements of one channel that are present in the + opposite channel are removed from the latter. This results in the + sound seeming further apart. + \item \textbf{Karaoke:} Removes all sound that is the same in both channels. + Since most vocals are recorded in this way to make the artist sound + central, this often (but not always) has the effect of removing the + voice track from a song. + \end{itemize} + } + \opt{h1xx,h300,ipodnano,ipodcolor,ipodvideo}{\textbf{TODO write for sw-platform} + +\opt{recorder,recorderv2fm}{ +\item \textbf{Loudness} Loudness is an effect which emphasises bass and treble. This makes the track seem louder by amplifying the frequencies that the human ear finds hard to hear. Frequencies in the vocal range are unaffected, since the human ear picks these up very easily. +} -\item \textbf{Auto Volume (Recorder only)} +\opt{recorder,recorderv2fm}{ +\item \textbf{Auto Volume} Auto volume is a feature that automatically lowers the volume on loud parts, and then slowly restores the volume to the previous level over a time interval. That time interval is configurable here. Short values @@ -78,15 +61,19 @@ other applications where background noise makes a constant loudness desirable. A longer timeout means that the change in volume back to the previous level will be smoother, so there will be less sharp changes in volume level. +} -\item \textbf{Super Bass (Recorder Only)} +\opt{recorder,recorderv2fm}{ +\item \textbf{Super Bass} This setting changes the threshold at which bass frequencies are affected by the \textbf{Loudness} setting, making the sound of drums and bass guitar louder in comparison to the rest of the track. This setting only has an effect if \textbf{Loudness} is set to a value larger than 0dB. +} -\item \textbf{MDB {}- Micronas Dynamic Bass (Recorder Only)} +\opt{recorder,recorderv2fm}{ +\item \textbf{MDB {}- Micronas Dynamic Bass} The rest of the parameters on this menu relate to the Micronas Dynamic Bass (MDB) function. This is designed to enable the user to hear bass notes that the headphones and/or speakers are not capable of @@ -128,7 +115,6 @@ For most users, the defaults should provide an improvement in sound quality and can be safely left as they are. For reference, the defaults Rockbox uses are: - \begin{table}[h!] \begin{center} \begin{tabular}{@{}lc@{}}\toprule @@ -143,6 +129,7 @@ defaults Rockbox uses are: \end{itemize} \end{itemize} +} \section{\label{ref:GeneralSettings}General Settings} {\centering\mdseries\itshape |