/*************************************************************************** * __________ __ ___. * Open \______ \ ____ ____ | | _\_ |__ _______ ___ * Source | _// _ \_/ ___\| |/ /| __ \ / _ \ \/ / * Jukebox | | ( <_> ) \___| < | \_\ ( <_> > < < * Firmware |____|_ /\____/ \___ >__|_ \|___ /\____/__/\_ \ * \/ \/ \/ \/ \/ * $Id$ * * Copyright (C) 2002 by Linus Nielsen Feltzing * * This program is free software; you can redistribute it and/or * modify it under the terms of the GNU General Public License * as published by the Free Software Foundation; either version 2 * of the License, or (at your option) any later version. * * This software is distributed on an "AS IS" basis, WITHOUT WARRANTY OF ANY * KIND, either express or implied. * ****************************************************************************/ #include "config.h" #include "cpu.h" .section .init.text,"ax",@progbits .global start start: move.w #0x2700,%sr move.l #vectors,%d0 movec.l %d0,%vbr move.l #MBAR+1,%d0 movec.l %d0,%mbar move.l #MBAR2+1,%d0 movec.l %d0,%mbar2 lea MBAR,%a0 lea MBAR2,%a1 clr.l (0x180,%a1) /* PLLCR = 0 */ /* 64K DMA-capable SRAM at 0x10000000 DMA is enabled and has priority in both banks All types of accesses are allowed (We might want to restrict that to save power) */ move.l #0x10000e01,%d0 movec.l %d0,%rambar1 /* 32K Non-DMA SRAM at 0x10010000 All types of accesses are allowed (We might want to restrict that to save power) */ move.l #0x10010001,%d0 movec.l %d0,%rambar0 /* Chip select 0 - Flash ROM */ moveq.l #0x00,%d0 /* CSAR0 - Base = 0x00000000 */ move.l %d0,(0x080,%a0) move.l #FLASH_SIZE-0x10000+1,%d0 /* CSMR0 - All access */ move.l %d0,(0x084,%a0) move.l #0x00000180,%d0 /* CSCR0 - no wait states, 16 bits, no bursts */ move.l %d0,(0x088,%a0) #ifndef IAUDIO_M3 /* Chip select 1 - LCD controller */ move.l #0xf0000000,%d0 /* CSAR1 - Base = 0xf0000000 */ move.l %d0,(0x08c,%a0) moveq.l #0x1,%d0 /* CSMR1 - 64K */ move.l %d0,(0x090,%a0) move.l #0x00000180,%d0 /* CSCR1 - no wait states, 16 bits, no bursts */ move.l %d0,(0x094,%a0) #endif /* Chip select 2 - ATA controller */ move.l #0x20000000,%d0 /* CSAR2 - Base = 0x20000000 */ move.l %d0,(0x098,%a0) moveq.l #0x1,%d0 /* CSMR2 - 64K */ move.l %d0,(0x09c,%a0) move.l #0x00000080,%d0 /* CSCR2 - no wait states, 16 bits, no bursts */ move.l %d0,(0x0a0,%a0) /* wait states are handled by the coldfire * IDE interface logic. */ #if defined(CONFIG_USBOTG) && CONFIG_USBOTG == USBOTG_ISP1362 /* Chip select 3 - USBOTG controller */ move.l #0xc0000000,%d0 /* CSAR3 - Base = 0xc0000000 */ move.l %d0,(0x0a4,%a0) moveq.l #0x1,%d0 /* CSMR3 - 64K */ move.l %d0,(0x0a8,%a0) move.l #0x00000180,%d0 /* CSCR3 - no wait states, 16 bits, no bursts */ move.l %d0,(0x0ac,%a0) #endif #ifdef BOOTLOADER /* Check if we have a Rockbox ROM image */ lea 0x00100000,%a2 move.l (%a2),%d0 move.l #FLASH_MAGIC,%d1 cmp.l %d0,%d1 beq.b .imagefound /* Check for RAM image */ lea 0x00001000,%a2 move.l (%a2),%d0 move.l #FLASH_MAGIC,%d1 cmp.l %d0,%d1 beq.b .imagefound /* Not either ROM or RAM image was found, so original firmware should be still present. */ /* Check if the cookie is present. */ lea 0x10017ffc,%a2 move.l (%a2),%d0 move.l #0xc0015a17,%d1 cmp.l %d0,%d1 bne.b .nocookie /* The cookie is not reset. This must mean that the boot loader has crashed. Let's start the original firmware immediately. */ lea 0x10017ffc,%a2 clr.l (%a2) jmp 8 .nocookie: /* Set the cookie */ move.l %d1,(%a2) .imagefound: /* Set up the DRAM controller. The refresh is based on the 11.2896MHz clock (5.6448MHz bus frequency). We haven't yet started the PLL */ #if MEM < 32 move.w #0x8004,%d0 /* DCR - Synchronous, 80 cycle refresh */ #else move.w #0x8001,%d0 /* DCR - Synchronous, 32 cycle refresh */ #endif move.w %d0,(0x100,%a0) /* Note on 32Mbyte models: We place the SDRAM on an 0x1000000 (16M) offset because the 5249 BGA chip has a fault which disables the use of A24. The suggested workaround by FreeScale is to offset the base address by half the DRAM size and increase the mask to the double. In our case this means that we set the base address 16M ahead and use a 64M mask. */ #if MEM < 32 move.l #0x31002324,%d0 /* DACR0 - Base 0x31000000, Banks on 21 and up, CAS latency 2, Page mode, No refresh yet */ move.l %d0,(0x108,%a0) move.l #0x00fc0001,%d0 /* Size: 16M */ move.l %d0,(0x10c,%a0) /* DMR0 - 32Mb */ #else move.l #0x31002524,%d0 /* DACR0 - Base 0x31000000, Banks on 23 and up, CAS latency 2, Page mode, No refresh yet */ move.l %d0,(0x108,%a0) move.l #0x03fc0001,%d0 /* Size: 64M because of workaround above */ move.l %d0,(0x10c,%a0) /* DMR0 - 32Mb */ #endif /* Precharge */ moveq.l #8,%d0 or.l %d0,(0x108,%a0) /* DACR0[IP] = 1, next access will issue a Precharge command */ move.l #0xabcd1234,%d0 move.l %d0,0x31000000 /* Issue precharge command */ move.l #0x8000,%d0 or.l %d0,(0x108,%a0) /* Enable refresh */ /* Let it refresh */ move.l #500,%d0 .delayloop: subq.l #1,%d0 bne.b .delayloop /* Mode Register init */ moveq.l #0x40,%d0 /* DACR0[IMRS] = 1, next access will set the Mode Register */ or.l %d0,(0x108,%a0) move.l #0xabcd1234,%d0 move.l %d0,0x31000800 /* A11=1 means CASL=2 (connected to SDRAM A5). */ /* DACR0[IMRS] gets deactivated by the SDRAM controller */ /* Check if we have a Rockbox ROM image. For RAM image only cookie is not set at all. But we could support also RAM images loading. */ lea 0x00100000,%a2 move.l (%a2),%d0 move.l #FLASH_MAGIC,%d1 cmp.l %d0,%d1 bne.b .noromimage /* Check again if the cookie is present. */ lea 0x10017ffc,%a2 move.l (%a2),%d0 move.l #0xc0015a17,%d1 cmp.l %d0,%d1 bne.b .nocookie2 /* We have found Rockbox in ROM! Clear the cookie and load the ROM image */ lea 0x10017ffc,%a2 clr.l (%a2) lea 0x00100028+4,%a2 move.l (%a2),%sp lea 0x00100028+8,%a2 move.l (%a2),%d0 move.l %d0,%a2 jmp (%a2) .nocookie2: /* Set the cookie */ move.l %d1,(%a2) .noromimage: #endif /* BOOTLOADER */ /* Invalicate cache */ move.l #0x01000000,%d0 movec.l %d0,%cacr /* Enable cache, default=non-cacheable, no buffered writes */ move.l #0x80000000,%d0 movec.l %d0,%cacr /* Cache enabled in SDRAM only, buffered writes enabled */ move.l #0x3103c020,%d0 movec.l %d0,%acr0 /* Buffered writes enabled for the LCD */ move.l #0xf000c060,%d0 movec.l %d0,%acr1 #ifndef BOOTLOADER /* .iram copy is done first since it is reclaimed for other * uninitialized sections */ /* copy the .iram section */ lea _iramcopy,%a2 lea _iramstart,%a3 lea _iramend,%a4 bra.b .iramstart .iramloop: move.l (%a2)+,(%a3)+ .iramstart: cmp.l %a3,%a4 bhi.b .iramloop /* zero out .ibss */ lea _iedata,%a2 lea _iend,%a4 bra.b .iedatastart .iedataloop: clr.l (%a2)+ .iedatastart: cmp.l %a2,%a4 bhi.b .iedataloop #endif /* !BOOTLOADER */ #ifdef IRIVER_H300_SERIES /* Set KEEP_ACT before doing the lengthy copy and zero-fill operations */ move.l #0x00080000,%d0 or.l %d0,(0xb4,%a1) or.l %d0,(0xb8,%a1) or.l %d0,(0xbc,%a1) #endif /* zero out bss */ lea _edata,%a2 lea _end,%a4 bra.b .edatastart .edataloop: clr.l (%a2)+ .edatastart: cmp.l %a2,%a4 bhi.b .edataloop /* copy the .data section */ lea _datacopy,%a2 lea _datastart,%a3 cmp.l %a2,%a3 beq.b .nodatacopy /* Don't copy if src and dest are equal */ lea _dataend,%a4 bra.b .datastart .dataloop: move.l (%a2)+,(%a3)+ .datastart: cmp.l %a3,%a4 bhi.b .dataloop .nodatacopy: /* Munge the main stack */ lea stackbegin,%a2 lea stackend,%a4 move.l %a4,%sp move.l #0xdeadbeef,%d0 .mungeloop: move.l %d0,(%a2)+ cmp.l %a2,%a4 bhi.b .mungeloop jsr main .hoo: bra.b .hoo .section .resetvectors vectors: .long stackend .long start