-------------------------------------------------------------------- __________ __ ___. Open \______ \ ____ ____ | | _\_ |__ _______ ___ Source | _// _ \_/ ___\| |/ /| __ \ / _ \ \/ / Jukebox | | ( <_> ) \___| < | \_\ ( <_> > < < Firmware |____|_ /\____/ \___ >__|_ \|___ /\____/__/\_ \ \/ \/ \/ \/ \/ $Id$ Copyright (C) 2002 by Linus Nielsen Feltzing -------------------------------------------------------------------- Debugging the Archos Jukebox ---------------------------- To debug using the serial port on the Jukebox, you need to do the following: 1) Connect the serial port to the PC. This is best done with the "serial port mod" described on the home page, along with a serial port converter for the 3V signals from the Jukebox. 2) Build or download a GDB SH1 cross debugger 3) Compile the GDB stub from the CVS "gdb" archive For Player models, just type: # make For Recorder, type #make RECORDER=1 4) Copy the newly built ARCHOS.MOD to the Jukebox. 5) Start the Jukebox and fire up the GDB with the elf file you want to debug as an argument along with the baud rate: For Player: # sh-elf-gdb -b 38400 test.elf For Recorder: # sh-elf-gdb -b 115200 test.elf 6) In GDB, type: (gdb) target remote /dev/ttyS0 /dev/ttyS0 is the serial port you want to use. I guess Windows users would type COM1 or something like that. GDB should answer with a message like: Remote debugging using /dev/ttyS0 0x090014b6 in ?? () (gdb) 7) Load the code from the elf file you specified on the command line: (gdb) load GDB should answer like this: Loading section .text, size 0x6b00 lma 0x9018000 Loading section .data, size 0x738 lma 0x901eb00 Start address 0x9018290, load size 29240 Transfer rate: 11696 bits/sec, 102 bytes/write. (gdb) 8) You're set. Now try to set a breakpoint and run: (gdb) b main Breakpoint 1 at 0x9011b2a: file main.c, line 192. (gdb) c Continuing. Breakpoint 1, main () at main.c:192 192 app_main(); (gdb) Good luck! Technical details: As for now, the GDB stub occupies the memory from 0x900000 up to 0x9018000. Compile and link your test program at 0x9018000 and up, and it will work. The baud rate is 38400 for Player, 115200 for Recorder, and the settings are 8N1. Note that you may have to change the ATA I/O address in the ATA_CONTROL macro in sh-stub.c. go to Menu->Debug (keep out)->View HW info to find out. Linus Nielsen Feltzing